Can I map or reconfigure BizTalk templates for VS?

Home Page › Forums › BizTalk 2004 – BizTalk 2010 › Can I map or reconfigure BizTalk templates for VS?

Viewing 2 reply threads
  • Author
    Posts
    • August 5, 2010 at 9:19 AM #25532
      community-content

        Hi.

        I’m running BTS 2009 and it was running fine.

        Now I had to install the Team Explorer for VS und I had to make some installations and Updates in VS.

        Now when I want to add a new project (File -> New -> Project -> BizTalk Project) I get an empty project. No references nothing … It seems to me like VS couldn’t find the templates are needed for a new BTS Project.

        I can’t configure BTS again and I can’t install it new, because lots of apps are running on it.

        Any ideas or tips?

        Thanks in advance.

        Wolfgang 

      • August 5, 2010 at 11:24 AM #25533
        community-content

          Yeah, you can. Even more – you can create new templates. I’ll look for the manual and if I find – post it here.

        • August 5, 2010 at 12:09 PM #25534
          community-content

            Well, didn’t find in the net, so I have written this post

            This what you ment in your question?

             

             

             

            • August 6, 2010 at 1:08 AM #25542
              community-content

                Hi Yonathan.

                Thank you very much for your link and help.

                I had a look thought it, but I think it is not what I’m looking for.

                I’m looking for all the standard templates come with BizTalk installation. At the moment I can’t add a new BizTalk Project in Visual Studio. I think this is because VS couldn’t find the BizTalk templates.

                To avoid a re-installation of BizTalk I hope there is a way to register the standard templates for VS again.

                Thanks

                Wolfgang

                • August 6, 2010 at 4:21 AM #25544
                  community-content

                    Ah, Ok.

                    Once I had problem similar to yours – run install of BizTalk – on repair mode, it takes couple of miniutes. No reconfiguring, no deleting of existing artifacts.

                    This worked in my case.

                    • August 6, 2010 at 4:25 AM #25545
                      community-content

                        Hi Yonathan.

                        You’re right – it works that way. Nothing get lost and works like before!

                        Thanks a lot … BTS is running like before.

                        Wolfgang

              • Author
                Posts
              Viewing 2 reply threads
              • The forum ‘BizTalk 2004 – BizTalk 2010’ is closed to new topics and replies.