Tranformation on a Orch

Home Page › Forums › BizTalk 2004 – BizTalk 2010 › Tranformation on a Orch

Viewing 3 reply threads
  • Author
    Posts
    • March 24, 2009 at 9:26 AM #21965
      community-content

        Hi, I might be being stupid here, but I have a Orch where I am doing a transform using an existing referenced map, however it will not allow me to select the desination message. It is set-up within the Orch and pointed at the correct Schema..

        Thanks in advance..

      • March 24, 2009 at 10:23 AM #21966
        community-content

          Did you reference to the schema’s project? Did you create messages for each schemas in ur orche?

          • March 24, 2009 at 2:08 PM #21972
            community-content

              Siva, Yes I have referenced the schema project and yes I have created messages for each schema…

               

              Any ideas?

              • March 24, 2009 at 2:20 PM #21973
                community-content

                  Could you give me more info? I am just biggner too.

                  Info such as when do you get error, what is the error message or screen shot.

                  • March 25, 2009 at 6:24 AM #21977
                    community-content

                      When you are in the transform shape, I select existing map point it towards the existing map I have in the referenced project, select the inbound message but it does not give me the option to select the outbound message..

                      Thanks.

              • March 25, 2009 at 11:15 PM #21983
                community-content

                  Are you using source control?

                  If the map is under source control, then it behaves as you have described.

                  Check out your map and it would allow you to configure the transform shape and the map.

                  Cheers

                  Bibhakar Saran

                   

                  • March 26, 2009 at 1:23 AM #21987
                    community-content

                      Hi, No I am not using source control..

                      • March 26, 2009 at 7:31 AM #21992
                        community-content

                          I think may be your map’s destination message type doesnt not exist in your orchestration messages, map is messed up or something wrong with reference for the destination message type. If you want, you can send the sample project to my email and I will take a look at it.

                    • April 1, 2009 at 5:06 PM #22069
                      community-content

                        Click on a Construct Message shape (the one around your Transform shape). Open properties, for a property Messages Constructed select your destination message from drop-down list.
                        After that you will be able to assign a destination message for your map.

                        Regards,

                        • April 3, 2009 at 3:01 AM #22070
                          community-content

                            Thanks for the posts, but still not solved it.. If I do a new map which creates a map within my Orch project I can select the destination message, If I select an exsiting map and select the referenced map I cannot select it..

                            any ideas?

                      • Author
                        Posts
                      Viewing 3 reply threads
                      • The forum ‘BizTalk 2004 – BizTalk 2010’ is closed to new topics and replies.