FTP adapter sees "no files to pick-up" as an error and shuts down

Home Page › Forums › BizTalk 2004 – BizTalk 2010 › FTP adapter sees "no files to pick-up" as an error and shuts down

Viewing 2 reply threads
  • Author
    Posts
    • December 19, 2007 at 11:03 AM #18659
      community-content

        Hi All,

        I have an FTP-receive-location against MVS. Works well when there are files to pick-up at the source.

        Without files to pick I get “550 No data sets found” followed by “QUIT”, this generates a “5740” warning in

        the eventlog “The adapter “FTP” raised an error message. Details “A failure occurred when parsing the remote folder listing. “.

        (This correspons the troubleshotGuide put we are using “active” firewall settings on handlers & locations.)

        This warning also increase the error counter and results in a shutdown when it reach the error threashold and

        also filling the eventlog with “dummy warnings”. This wasn’t an issue in BTS2004.

        Cheers,

        Bjorn

         

      • December 25, 2007 at 6:36 PM #18680
        community-content

          Are you using any custom Pre or Post FTP commands.

          Ideally it used to work fine with 2004 then it should work with 2006 too……

        • December 27, 2007 at 7:14 AM #18687
          community-content

            Do you have any filters set – such as “*.txt”  ?  If not, perhaps you should try setting a filter to avoid having BizTalk look for everything. 

        • Author
          Posts
        Viewing 2 reply threads
        • The forum ‘BizTalk 2004 – BizTalk 2010’ is closed to new topics and replies.